Simulation of Doubly Fed Induction generator (DFIG) for Steady state analysis when connected to a wind farm for power system stability

Main Article Content

Njeh Edwin Mbabit
David Afungchui
Joseph Ebobenow
Ali Helali
Charles Tabod

Abstract

In this paper, a 2MW variable speed, pitch-regulated Doubly-fed Induction Generator (DFIG) with a speed range of 800-2000 rpm was studied for steady-state analysis. The DFIG was modelled in the Matlab/Simulink environment. The rotor-side converter utilized closed-loop stator flux-oriented vector control for managing the DFIG model. This method allows for rapid control and experimenting of grid-connected, variable speed DFIG wind turbines to examine their steady-state and energetic characteristics beneath ordinary and disturbed wind conditions when connected to a wind farm. The steady-state behavior of the wind turbine generator was derived at two different magnetizing levels: one with the reactive power of the stator equal to zero (Qs = 0), and the other with the direct current of the rotor equal to zero (Idr = 0). Simulation results show that the machine has higher efficiency when magnetized through the stator as compared with magnetization of the machine through the rotor. To come out with the DFIG transitory stability simulation results traditional controllers' for active and reactive power were compared with an adaptive adaptive tracking, self-tuned feedforward proportional integral regulating model for peak performance. Additionally, stability and instability were studied by solving the Swing equation using the Runge-Kutta method of order four. In a steady-state condition for the generator, the acceleration torque (Ta) reaches zero, which signifies that the mechanical torque (Tm) matches the electrical torque (Te). In the stability investigation, Tm is assumed to be constant. The findings provide valuable insights into the control strategies required for enhancing the reliability and efficiency of wind turbines in variable wind conditions.

Article Details

How to Cite
[1]
N. Edwin Mbabit, D. . Afungchui, J. . Ebobenow, A. . Helali, and C. . Tabod, “Simulation of Doubly Fed Induction generator (DFIG) for Steady state analysis when connected to a wind farm for power system stability”, J. Ren. Energies, vol. 27, no. 2, pp. 151 -, Dec. 2024.
Section
Articles

References

Anderson, L. E. Anaya-Lara, O., Tande, J O., Merz, K O., & Imsland, L. (2021). Wind farm control - Part I: A review on control system concepts and structures. IET Renewable Power Generation, 15(10), 2085-2108. https://doi.org/10.1049/rpg2.12160

Arnaltes, S., Rodriguez-Amenedo, J. L., & Montilla-D Jesus, M. E. (n.d.). Control of variable.

Artigao, E., Martin-Martinez, S., Honrubia-Escribano, A., & Gomez-Lazaro, E. (2018). Wind turbine reliability: A comprehensive review towards effective condition monitoring development. Applied Energy, 228, 1569-1583. https://doi.org/10.1016/j.apenergy.2018.07.037

Boukili, Y., Aguiar, A. P., & Carvalho, A. (2020). A DFIG-based Wind Turbine Operation under Balanced and Unbalanced Grid Voltage Conditions. IFAC-PapersOnLine, 53(2), 12835-12840. https://doi.org/10.1016/j.ifacol.2020.12.1977

Chan, T. F., Lai, L. L., & Yan, L.-T. (2004). Performance of a Three-Phase AC Generator With Inset NdFeB Permanent-Magnet Rotor. IEEE Transactions on Energy Conversion, 19(1), 88-94. https://doi.org/10.1109/TEC.2003.821861

Chen, Y., & Smedley, K. (2008). Three-Phase Boost-Type Grid-Connected Inverter. IEEE Transactions on Power Electronics, 23(5), 2301–2309. https://doi.org/10.1109/TPEL.2008.2003025

Contreras Quispe, M. I., Caceres Cardenas, F. V., & Quispe, E. C. (2018). A Method for Steady State Analysis of Doubly Fed Induction Generator. 2018 IEEE ANDESCON, 1–7. https://doi.org/10.1109/ANDESCON.2018.8564721

Dahbi, A., Nait-Said, N., & Nait-Said, M.-S. (2016). A novel combined MPPT-pitch angle control for wide range variable speed wind turbine based on neural network. International Journal of Hydrogen Energy, 41(22), 9427–9442. https://doi.org/10.1016/j.ijhydene.2016.03.105

Dao, C., Kazemtabrizi, B., & Crabtree, C. (2019). Wind turbine reliability data review and impacts on levelised cost of energy. Wind Energy, 22(12), 1848–1871. https://doi.org/10.1002/we.2404

Eltamaly, A. M., Al-Saud, M., Sayed, K., & Abo-Khalil, A. G. (2020). Sensorless Active and Reactive Control for DFIG Wind Turbines Using Opposition-Based Learning Technique. Sustainability, 12(9), 3583. https://doi.org/10.3390/su12093583

Fortmann, J. (2015). Modeling of Wind Turbines with Doubly Fed Generator System. Springer Fachmedien Wiesbaden. https://doi.org/10.1007/978-3-658-06882-0

Gianto, R. (2021). Steady-state model of DFIG-based wind power plant for load flow analysis. IET Renewable Power Generation, 15(8), 1724-1735. https://doi.org/10.1049/rpg2.12141

Hansen, A. D., & Michalke, G. (2008). Modelling and control of variable-speed multi-pole permanent magnet synchronous generator wind turbine. Wind Energy, 11(5), 537-554. https://doi.org/10.1002/we.278

Haque, M. E., Negnevitsky, M., & Muttaqi, K. M. (2010). A Novel Control Strategy for a Variable-Speed Wind Turbine With a Permanent-Magnet Synchronous Generator. IEEE Transactions on Industry Applications, 46(1), 331-339. https://doi.org/10.1109/TIA.2009.2036550

Heier, S. (2006). Grid integration of wind energy conversion systems (2nd ed). Wiley.

Hua Geng, Geng Yang, Dewei Xu, & Bin Wu. (2011). Unified Power Control for PMSG-Based WECS Operating Under Different Grid Conditions. IEEE Transactions on Energy Conversion, 26(3), 822–830. https://doi.org/10.1109/TEC.2011.2127478

I., N., Zhao, G., Yamin, Z., & Gul, w. (2020, November 19). Steady State performance Analysis of DFIG with Different Magnetizing Strategies in a Pitch-Regulated Variable Speed Wind Turbine. Proceeding of the 2020 4th International Conference on Power and Energy Engineering (ICPEE.

Kaloi, G. S., Wang, J., & Baloch, M. H. (2016). Active and reactive power control of the doubly fed induction generator based on wind energy conversion system. Energy Reports, 2, 194–200. https://doi.org/10.1016/j.egyr.2016.08.001

Karakasis, N., Tsioumas, E., Jabbour, N., Bazzi, A. M., & Mademlis, C. (2019). Optimal Efficiency Control in a Wind System With Doubly Fed Induction Generator. IEEE Transactions on Power Electronics, 34(1), 356–368. https://doi.org/10.1109/TPEL.2018.2823481

Karimirad, M. (2014). Offshore energy structures for wind power, wave energy and hybrid marine platforms. Springer.

Keramat Siavash, N., Najafi, G., Tavakkoli Hashjin, T., Ghobadian, B., & Mahmoodi, E. (2020). Mathematical modeling of a horizontal axis shrouded wind turbine. Renewable Energy, 146, 856–866. https://doi.org/10.1016/j.renene.2019.07.022

Li, S., & Li, L. (2021). Steady-state Solution and Evaluation Indices of DFIG Operating at Synchronous Speed (sDFIG). 2021 IEEE Sustainable Power and Energy Conference (iSPEC), 260–267. https://doi.org/10.1109/iSPEC53008.2021.9736024

Mastoi, M. S., Tahir, M. J., Usman, M., Wang, D., Zhuang, S., & Hassan, M. (2022). Research on power system transient stability with wind generation integration under fault condition to achieve economic benefits. IET Power Electronics, 15(3), 263–274. https://doi.org/10.1049/pel2.12228

Mousa, H. H. H., Youssef, A.-R., & Mohamed, E. E. M. (2021). State of the art perturb and observe MPPT algorithms based wind energy conversion systems: A technology review. International Journal of Electrical Power & Energy Systems, 126, 106598. https://doi.org/10.1016/j.ijepes.2020.106598

Müller, S., Deicke, M., & Doncker, R. W. (2002). Doubly fed induction generator system for wind turbines. IEEE Ind. Appl. Mag, 8(3), 26-33,.

Njiri, J. G., & Söffker, D. (2016). State-of-the-art in wind turbine control: Trends and challenges. Renewable and Sustainable Energy Reviews, 60, 377–393. https://doi.org/10.1016/j.rser.2016.01.110

Nora, Z., Nadai, B., & Nadia. (2018, October 25). B.S.A. contribution to PI Control Speed of a Doubly Fed Induction Motor. Proceeding of the 2018 6th International Conference on Contro Engineering $ International Technology (CEIT.

Pande, J., Nasikkar, P., Kotecha, K., & Varadarajan, V. (2021). A Review of Maximum Power Point Tracking Algorithms for Wind Energy Conversion Systems. Journal of Marine Science and Engineering, 9(11), 1187. https://doi.org/10.3390/jmse9111187

Robinson, J., Jovcic, D., & Joos, G. (2010). Analysis and Design of an Offshore Wind Farm Using a MV DC Grid. IEEE Transactions on Power Delivery, 25(4), 2164–2173. https://doi.org/10.1109/TPWRD.2010.2053390

Sharawy, M., Shaltout, A. A., Abdel-Rahim, N., Youssef, O. E. M., & Al-Ahmar, M. A. (2021). Simplified Steady State Analysis of Stand-Alone Doubly Fed Induction Generator. 2021 22nd International Middle East Power Systems Conference (MEPCON), 246–251. https://doi.org/10.1109/MEPCON50283.2021.9686219

Shourangiz-Haghighi, A., Haghnegahdar, M. A., Wang, L., Mussetta, M., Kolios, A., & Lander, M. (2020). State of the Art in the Optimisation of Wind Turbine Performance Using CFD. Archives of Computational Methods in Engineering, 27(2), 413–431. https://doi.org/10.1007/s11831-019-09316-0

Tanvir, A., Merabet, A., & Beguenane, R. (2015). Real-Time Control of Active and Reactive Power for Doubly Fed Induction Generator (DFIG)-Based Wind Energy Conversion System. Energies, 8(9), 10389–10408. https://doi.org/10.3390/en80910389

Xu, H., Nian, H., Xu, H., He, & Yikang. (2011). Dynamic modeling and improved control of DFIG under unbalanced and distorted grid voltage conditions. Transactions On Energy Conversion, 26, 1,. https://doi.org/10.1109/ISIE.2012.6237327

Zerzeri, M., Jallali, F., & Khedher, A. (2019). Robust FOC Analysis of a DFIM using an SMFO: Application to Electric Vehicles. 2019 International Conference on Signal, Control and Communication (SCC), 250–255. https://doi.org/10.1109/SCC47175.2019.9116160

Zhou, Z., Mastoi, M. S., Wang, D., & Haris, M. (2023). Control strategy of DFIG and SVG cooperating to regulate grid voltage of wind power integration point. Electric Power Systems Research, 214, 108862. https://doi.org/10.1016/j.epsr.2022.108862